Hewlett-Packard photosmart 7900 series DOT4 - two ways of downloading and installing the driver

photosmart 7900 series DOT4 is a Dot4 hardware device. This driver was developed by Hewlett-Packard. In order to make sure you are downloading the exact right driver the hardware id is dot4usb/vid_03f0&pid_b702&mi_01&dot4.

1. How to manually install Hewlett-Packard photosmart 7900 series DOT4 driver

1. You can download from the link below the driver setup file for the Hewlett-Packard photosmart 7900 series DOT4 driver. The archive contains version 10.1.1.3 released on 2009-09-15 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is not digitally signed.

This driver received an average rating of 3.8 stars out of 20224 votes.

2. How to use DriverMax to install Hewlett-Packard photosmart 7900 series DOT4 driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's see!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Hewlett-Packard photosmart 7900 series DOT4 driver. Click on Update.
4.  
5. Finished installing the driver!
6.