Hewlett-Packard photosmart 140 series DOT4USB driver download and installation

photosmart 140 series DOT4USB is a USB Universal Serial Bus device. The Windows version of this driver was developed by Hewlett-Packard. The hardware id of this driver is usb/vid_03f0&pid_1002&mi_01.

1. Hewlett-Packard photosmart 140 series DOT4USB driver - how to install it manually

1. You can download from the link below the driver installer file for the Hewlett-Packard photosmart 140 series DOT4USB driver. The archive contains version 15.3.1.10527 released on 2011-07-01 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

There is no digital signature available for this driver.

Driver rating 3.1 stars out of 46826 votes.

2. How to install Hewlett-Packard photosmart 140 series DOT4USB driver using DriverMax

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the Hewlett-Packard photosmart 140 series DOT4USB driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.