Foxlink USB2.0 UVC 1.3M Webcam - two ways of downloading and installing the driver

USB2.0 UVC 1.3M Webcam is a Imaging Devices device. This driver was developed by Foxlink. USB/VID_05C8&PID_030D&MI_00 is the matching hardware id of this device.

1. How to manually install Foxlink USB2.0 UVC 1.3M Webcam driver

1. Download the driver setup file for Foxlink USB2.0 UVC 1.3M Webcam driver from the link below. This is the download link for the driver version 6.2.9200.10295 dated 2014-11-21.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.

This driver received an average rating of 3.9 stars out of 4870 votes.

2. How to install Foxlink USB2.0 UVC 1.3M Webcam driver using DriverMax

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Foxlink USB2.0 UVC 1.3M Webcam driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.