Driver for Foxlink USB2.0 UVC 1.3M WebCam - downloading and installing it

USB2.0 UVC 1.3M WebCam is a Imaging Devices hardware device. The developer of this driver was Foxlink. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_05C8&PID_0311&MI_00.

1. Manually install Foxlink USB2.0 UVC 1.3M WebCam driver

1. You can download from the link below the driver setup file for the Foxlink USB2.0 UVC 1.3M WebCam driver. The archive contains version 6.2.9200.10277 dated 2014-05-16 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is running please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

There is no digital signature available for this driver.

Driver rating 3.5 stars out of 9178 votes.

2. How to install Foxlink USB2.0 UVC 1.3M WebCam driver using DriverMax

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the Foxlink USB2.0 UVC 1.3M WebCam driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.