Driver for eGalaxTouch USB Touchscreen Controller EMR90 - downloading and installing it

USB Touchscreen Controller EMR90 is a Mouse hardware device. The Windows version of this driver was developed by eGalaxTouch. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_0EEF&PID_4890.

1. Install eGalaxTouch USB Touchscreen Controller EMR90 driver manually

1. You can download from the link below the driver setup file for the eGalaxTouch USB Touchscreen Controller EMR90 driver. The archive contains version 5.8.0.7210 dated 2009-11-10 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver was not digitally signed.

This driver received an average rating of 3.3 stars out of 5196 votes.

2. Using DriverMax to install eGalaxTouch USB Touchscreen Controller EMR90 driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's see!

1. Start DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the eGalaxTouch USB Touchscreen Controller EMR90 driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.