National Instruments USB Flash Firmware Updater - two ways of downloading and installing the driver

USB Flash Firmware Updater is a DAQ Device hardware device. This Windows driver was developed by National Instruments. USB/VID_3923&PID_735B is the matching hardware id of this device.

1. National Instruments USB Flash Firmware Updater driver - how to install it manually

1. You can download from the link below the driver setup file for the National Instruments USB Flash Firmware Updater driver. The archive contains version 23.0.0.49362 released on 2023-01-14 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver was not digitally signed.

Driver rating 3.7 stars out of 68446 votes.

2. Installing the National Instruments USB Flash Firmware Updater driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the National Instruments USB Flash Firmware Updater driver. Click on Update.
4.  
5. Finished installing the driver!
6.