National Instruments USB Flash Firmware Updater - two ways of downloading and installing the driver

USB Flash Firmware Updater is a DAQ Device device. The developer of this driver was National Instruments. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_3923&PID_735B.

1. How to manually install National Instruments USB Flash Firmware Updater driver

1. Download the setup file for National Instruments USB Flash Firmware Updater driver from the location below. This download link is for the driver version 22.8.0.49361 dated 2022-10-02.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

This driver received an average rating of 3.2 stars out of 80147 votes.

2. Using DriverMax to install National Instruments USB Flash Firmware Updater driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the National Instruments USB Flash Firmware Updater driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.