National Instruments USB Firmware Updater - two ways of downloading and installing the driver

USB Firmware Updater is a DAQ Device device. This driver was developed by National Instruments. The hardware id of this driver is USB/VID_3923&PID_76F9&REV_0100&MI_00.

1. Install National Instruments USB Firmware Updater driver manually

1. You can download from the link below the driver setup file for the National Instruments USB Firmware Updater driver. The archive contains version 22.5.0.49247 dated 2022-07-07 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

National Instruments applied a digital signature to this driver.
The file size of this driver is 41903 bytes (40.92 KB)
This driver was installed by many users and received an average rating of 4.9 stars out of 27967 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install National Instruments USB Firmware Updater driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the National Instruments USB Firmware Updater driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.