National Instruments USB Firmware Updater - two ways of downloading and installing the driver

USB Firmware Updater is a DAQ Device hardware device. The Windows version of this driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_3923&PID_7254.

1. National Instruments USB Firmware Updater - install the driver manually

1. Download the setup file for National Instruments USB Firmware Updater driver from the link below. This is the download link for the driver version 23.3.0.49318 released on 2023-04-02.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your User Access Control (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be pretty straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.

This driver was rated with an average of 3.7 stars by 57047 users.

2. How to use DriverMax to install National Instruments USB Firmware Updater driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Search the list until you find the National Instruments USB Firmware Updater driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.