National Instruments USB Firmware Loader - two ways of downloading and installing the driver

USB Firmware Loader is a DAQ Device device. This Windows driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_3923&PID_7269&REV_0100.

1. National Instruments USB Firmware Loader - install the driver manually

1. You can download from the link below the driver setup file for the National Instruments USB Firmware Loader driver. The archive contains version 23.3.0.49318 dated 2023-04-02 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is not digitally signed.

This driver received an average rating of 3 stars out of 56938 votes.

2. How to install National Instruments USB Firmware Loader driver using DriverMax

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you find the National Instruments USB Firmware Loader driver. Click on Update.
4.  
5. Finished installing the driver!
6.