Download and install National Instruments USB DAQ driver

USB DAQ is a DAQ Device device. This driver was developed by National Instruments. USB/VID_3923&PID_7599&REV_0100 is the matching hardware id of this device.

1. Manually install National Instruments USB DAQ driver

1. Download the setup file for National Instruments USB DAQ driver from the link below. This is the download link for the driver version 18.5.0.49153 released on 2018-09-27.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the new driver, it is as simple as that.
8.  

This driver is digitally signed.
Size of this driver: 52214 bytes (50.99 KB)
This driver was rated with an average of 4.6 stars by 57098 users.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 2000 32 bits
• This driver works on Windows Server 2003 32 bits
• This driver works on Windows XP 32 bits
• This driver works on Windows Vista 32 bits
• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. The easy way: using DriverMax to install National Instruments USB DAQ driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the National Instruments USB DAQ driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.