National Instruments USB DAQ - two ways of downloading and installing the driver

USB DAQ is a DAQ Device device. This driver was developed by National Instruments. The hardware id of this driver is USB/VID_3923&PID_7364&REV_0100.

1. National Instruments USB DAQ - install the driver manually

1. You can download from the link below the driver installer file for the National Instruments USB DAQ driver. The archive contains version 19.5.0.49152 dated 2019-09-10 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your UAC (User Access Control) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is digitally signed.
File size of the driver: 74164 bytes (72.43 KB)
Driver rating 4.3 stars out of 89029 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Installing the National Instruments USB DAQ driver using DriverMax: the easy way

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's see!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you locate the National Instruments USB DAQ driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.