National Instruments USB-9472 - two ways of downloading and installing the driver

USB-9472 is a DAQ Device device. The Windows version of this driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_3923&PID_70A1&REV_0100.

1. Manually install National Instruments USB-9472 driver

1. Download the setup file for National Instruments USB-9472 driver from the link below. This is the download link for the driver version 23.0.0.49364 dated 2023-01-14.
2.  
3. Run the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be quite easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.

This driver was rated with an average of 3.6 stars by 74126 users.

2. Using DriverMax to install National Instruments USB-9472 driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the National Instruments USB-9472 driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.