Driver for National Instruments USB-9472 - downloading and installing it

USB-9472 is a DAQ Device hardware device. This driver was developed by National Instruments. USB/VID_3923&PID_70A1&REV_0100 is the matching hardware id of this device.

1. Manually install National Instruments USB-9472 driver

1. You can download from the link below the driver setup file for the National Instruments USB-9472 driver. The archive contains version 22.5.0.49248 dated 2022-07-07 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is not digitally signed.

This driver was rated with an average of 4 stars by 12846 users.

2. Installing the National Instruments USB-9472 driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the National Instruments USB-9472 driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.