Download and install National Instruments USB-6366 64 MS Mass Termination driver

USB-6366 64 MS Mass Termination is a DAQ Device device. The developer of this driver was National Instruments. The hardware id of this driver is USB/VID_3923&PID_75A1&REV_0100.

1. How to manually install National Instruments USB-6366 64 MS Mass Termination driver

1. Download the driver setup file for National Instruments USB-6366 64 MS Mass Termination driver from the link below. This is the download link for the driver version 23.0.0.49362 released on 2023-01-14.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which should be pretty easy to follow. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.

Driver rating 3.3 stars out of 67319 votes.

2. Installing the National Instruments USB-6366 64 MS Mass Termination driver using DriverMax: the easy way

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the National Instruments USB-6366 64 MS Mass Termination driver. Click on Update.
4.  
5. Finished installing the driver!
6.