National Instruments USB-6366 64 MS Mass Termination - two ways of downloading and installing the driver

USB-6366 64 MS Mass Termination is a DAQ Device hardware device. The developer of this driver was National Instruments. The hardware id of this driver is USB/VID_3923&PID_75A1&REV_0100.

1. How to manually install National Instruments USB-6366 64 MS Mass Termination driver

1. You can download from the link below the driver setup file for the National Instruments USB-6366 64 MS Mass Termination driver. The archive contains version 22.8.0.49361 released on 2022-10-02 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is running please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver was not digitally signed.

This driver received an average rating of 3.9 stars out of 77760 votes.

2. How to install National Instruments USB-6366 64 MS Mass Termination driver using DriverMax

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the National Instruments USB-6366 64 MS Mass Termination driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.