Driver for National Instruments USB-6363 Mass Termination - downloading and installing it

USB-6363 Mass Termination is a DAQ Device hardware device. The developer of this driver was National Instruments. The hardware id of this driver is USB/VID_3923&PID_759E&MI_00.

1. Manually install National Instruments USB-6363 Mass Termination driver

1. You can download from the link below the driver setup file for the National Instruments USB-6363 Mass Termination driver. The archive contains version 23.0.0.49362 dated 2023-01-14 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

Driver rating 3.5 stars out of 67506 votes.

2. Installing the National Instruments USB-6363 Mass Termination driver using DriverMax: the easy way

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the National Instruments USB-6363 Mass Termination driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.