National Instruments USB-6363 BNC - two ways of downloading and installing the driver

USB-6363 BNC is a DAQ Device hardware device. The Windows version of this driver was developed by National Instruments. The hardware id of this driver is USB/VID_3923&PID_75DD&REV_0100.

1. Manually install National Instruments USB-6363 BNC driver

1. You can download from the link below the driver setup file for the National Instruments USB-6363 BNC driver. The archive contains version 22.5.0.49247 released on 2022-07-07 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is started please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver was not digitally signed.

This driver received an average rating of 3.6 stars out of 35698 votes.

2. Using DriverMax to install National Instruments USB-6363 BNC driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Search the list until you find the National Instruments USB-6363 BNC driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.