National Instruments USB-6361 Mass Termination - two ways of downloading and installing the driver

USB-6361 Mass Termination is a DAQ Device device. This driver was developed by National Instruments. The hardware id of this driver is USB/VID_3923&PID_759D&REV_0100&MI_00.

1. Install National Instruments USB-6361 Mass Termination driver manually

1. You can download from the link below the driver installer file for the National Instruments USB-6361 Mass Termination driver. The archive contains version 22.5.0.49247 released on 2022-07-07 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is not digitally signed.

This driver received an average rating of 3.4 stars out of 36022 votes.

2. How to use DriverMax to install National Instruments USB-6361 Mass Termination driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the National Instruments USB-6361 Mass Termination driver. Click the Update button.
4.  
5. Finished installing the driver!
6.