National Instruments USB-6361 BNC how to download and install the driver

USB-6361 BNC is a DAQ Device device. The developer of this driver was National Instruments. USB/VID_3923&PID_75DC&REV_0100 is the matching hardware id of this device.

1. National Instruments USB-6361 BNC - install the driver manually

1. Download the driver setup file for National Instruments USB-6361 BNC driver from the link below. This download link is for the driver version 23.0.0.49362 dated 2023-01-14.
2.  
3. Run the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

Driver rating 4 stars out of 67279 votes.

2. The easy way: using DriverMax to install National Instruments USB-6361 BNC driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the National Instruments USB-6361 BNC driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.