Download and install National Instruments USB-6351 driver

USB-6351 is a DAQ Device device. The Windows version of this driver was developed by National Instruments. The hardware id of this driver is USB/VID_3923&PID_74FA.

1. Manually install National Instruments USB-6351 driver

1. You can download from the link below the driver setup file for the National Instruments USB-6351 driver. The archive contains version 22.5.0.49247 released on 2022-07-07 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your UAC (User Access Control) is running please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver was not digitally signed.

This driver received an average rating of 4 stars out of 38085 votes.

2. How to use DriverMax to install National Instruments USB-6351 driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's take a look!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the National Instruments USB-6351 driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.