National Instruments USB-6343 - two ways of downloading and installing the driver

USB-6343 is a DAQ Device device. The Windows version of this driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_3923&PID_74F7&REV_0100&MI_00.

1. How to manually install National Instruments USB-6343 driver

1. Download the setup file for National Instruments USB-6343 driver from the location below. This is the download link for the driver version 23.0.0.49362 dated 2023-01-14.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control Service (UAC) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

There is no digital signature available for this driver.

This driver was rated with an average of 3.8 stars by 68355 users.

2. How to install National Instruments USB-6343 driver using DriverMax

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's take a look!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the National Instruments USB-6343 driver. Click the Update button.
4.  
5. Finished installing the driver!
6.