Driver for National Instruments USB-6343 - downloading and installing it

USB-6343 is a DAQ Device hardware device. This Windows driver was developed by National Instruments. The hardware id of this driver is USB/VID_3923&PID_74F7.

1. National Instruments USB-6343 driver - how to install it manually

1. Download the setup file for National Instruments USB-6343 driver from the link below. This is the download link for the driver version 23.0.0.49362 dated 2023-01-14.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, as you can see it was quite smple.
8.  

There is no digital signature available for this driver.

Driver rating 4 stars out of 68485 votes.

2. How to use DriverMax to install National Instruments USB-6343 driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's see!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the National Instruments USB-6343 driver. Click on Update.
4.  
5. Finished installing the driver!
6.