Driver for National Instruments USB-6343 BNC - downloading and installing it

USB-6343 BNC is a DAQ Device hardware device. This Windows driver was developed by National Instruments. The hardware id of this driver is USB/VID_3923&PID_75DB&REV_0100.

1. Install National Instruments USB-6343 BNC driver manually

1. You can download from the link below the driver setup file for the National Instruments USB-6343 BNC driver. The archive contains version 22.5.0.49247 dated 2022-07-07 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver was not digitally signed.

This driver received an average rating of 3.2 stars out of 35777 votes.

2. The easy way: using DriverMax to install National Instruments USB-6343 BNC driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the National Instruments USB-6343 BNC driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.