Download and install National Instruments USB-6341 driver

USB-6341 is a DAQ Device hardware device. This driver was developed by National Instruments. The hardware id of this driver is USB/VID_3923&PID_74F8&REV_0100&MI_00.

1. Install National Instruments USB-6341 driver manually

1. Download the setup file for National Instruments USB-6341 driver from the location below. This is the download link for the driver version 22.5.0.49247 dated 2022-07-07.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, it is as simple as that.
8.  

This driver was not digitally signed.

Driver rating 3.6 stars out of 38194 votes.

2. The easy way: using DriverMax to install National Instruments USB-6341 driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the National Instruments USB-6341 driver. Click on Update.
4.  
5. Finished installing the driver!
6.