National Instruments USB-6341 BNC - two ways of downloading and installing the driver

USB-6341 BNC is a DAQ Device hardware device. This driver was developed by National Instruments. The hardware id of this driver is USB/VID_3923&PID_75DA&REV_0100&MI_00.

1. National Instruments USB-6341 BNC - install the driver manually

1. Download the setup file for National Instruments USB-6341 BNC driver from the link below. This is the download link for the driver version 22.8.0.49361 dated 2022-10-02.
2.  
3. Start the driver setup file from a Windows account with administrative rights. If your User Access Control (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the new driver, as you can see it was quite smple.
8.  

This driver was not digitally signed.

Driver rating 3.2 stars out of 77651 votes.

2. How to use DriverMax to install National Instruments USB-6341 BNC driver

The most important advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the National Instruments USB-6341 BNC driver. Click the Update button.
4.  
5. Finished installing the driver!
6.