National Instruments USB-6341 BNC how to download and install the driver

USB-6341 BNC is a DAQ Device device. This Windows driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_3923&PID_75DA&REV_0100&MI_00.

1. National Instruments USB-6341 BNC - install the driver manually

1. You can download from the link below the driver setup file for the National Instruments USB-6341 BNC driver. The archive contains version 18.5.0.49153 dated 2018-09-27 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is digitally signed by National Instruments.
Driver file size: 52214 bytes (50.99 KB)
This driver received an average rating of 4.5 stars out of 55412 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 2000 32 bits
• This driver works on Windows Server 2003 32 bits
• This driver works on Windows XP 32 bits
• This driver works on Windows Vista 32 bits
• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. Using DriverMax to install National Instruments USB-6341 BNC driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the National Instruments USB-6341 BNC driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.