National Instruments USB-6341 BNC driver download and installation

USB-6341 BNC is a DAQ Device hardware device. The developer of this driver was National Instruments. The hardware id of this driver is USB/VID_3923&PID_75DA&MI_00.

1. National Instruments USB-6341 BNC - install the driver manually

1. You can download from the link below the driver setup file for the National Instruments USB-6341 BNC driver. The archive contains version 23.0.0.49362 released on 2023-01-14 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

This driver was installed by many users and received an average rating of 3.3 stars out of 67349 votes.

2. How to use DriverMax to install National Instruments USB-6341 BNC driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you find the National Instruments USB-6341 BNC driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.