Driver for National Instruments USB-6289 - downloading and installing it

USB-6289 is a DAQ Device hardware device. The developer of this driver was National Instruments. The hardware id of this driver is USB/VID_3923&PID_7343&REV_0100.

1. Manually install National Instruments USB-6289 driver

1. Download the driver setup file for National Instruments USB-6289 driver from the link below. This is the download link for the driver version 23.3.0.49318 dated 2023-04-02.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite straightforward. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the new driver, it is as simple as that.
8.  

This driver is not digitally signed.

This driver was installed by many users and received an average rating of 3.3 stars out of 57669 votes.

2. Using DriverMax to install National Instruments USB-6289 driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the National Instruments USB-6289 driver. Click on Update.
4.  
5. Finished installing the driver!
6.