National Instruments USB-6289 how to download and install the driver

USB-6289 is a DAQ Device device. The Windows version of this driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_3923&PID_7343&REV_0100.

1. Manually install National Instruments USB-6289 driver

1. You can download from the link below the driver setup file for the National Instruments USB-6289 driver. The archive contains version 19.5.0.49152 released on 2019-09-10 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is running please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is digitally signed by National Instruments.
Size of this driver: 74164 bytes (72.43 KB)
This driver was installed by many users and received an average rating of 4.9 stars out of 88081 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 2000 64 bits
• This driver works on Windows Server 2003 64 bits
• This driver works on Windows XP 64 bits
• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install National Instruments USB-6289 driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the National Instruments USB-6289 driver. Click on Update.
4.  
5. Finished installing the driver!
6.