Driver for National Instruments USB-6281 Mass Termination - downloading and installing it

USB-6281 Mass Termination is a DAQ Device hardware device. The Windows version of this driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_3923&PID_7340&REV_0100.

1. National Instruments USB-6281 Mass Termination - install the driver manually

1. You can download from the link below the driver installer file for the National Instruments USB-6281 Mass Termination driver. The archive contains version 23.3.0.49318 released on 2023-04-02 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

There is no digital signature available for this driver.

This driver was installed by many users and received an average rating of 3.7 stars out of 57648 votes.

2. Using DriverMax to install National Instruments USB-6281 Mass Termination driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's see!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the National Instruments USB-6281 Mass Termination driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.