National Instruments USB-6251 Mass Termination - two ways of downloading and installing the driver

USB-6251 Mass Termination is a DAQ Device hardware device. This Windows driver was developed by National Instruments. The hardware id of this driver is USB/VID_3923&PID_72A0&REV_0100.

1. National Instruments USB-6251 Mass Termination - install the driver manually

1. You can download from the link below the driver setup file for the National Instruments USB-6251 Mass Termination driver. The archive contains version 23.3.0.49318 dated 2023-04-02 of the driver.
2.  
3. Run the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is not digitally signed.

This driver received an average rating of 3.8 stars out of 58044 votes.

2. Using DriverMax to install National Instruments USB-6251 Mass Termination driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you find the National Instruments USB-6251 Mass Termination driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.