National Instruments USB-6212 Mass Termination how to download and install the driver

USB-6212 Mass Termination is a DAQ Device hardware device. This Windows driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_3923&PID_7389&REV_0100.

1. Manually install National Instruments USB-6212 Mass Termination driver

1. You can download from the link below the driver setup file for the National Instruments USB-6212 Mass Termination driver. The archive contains version 23.3.0.49318 dated 2023-04-02 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your User Access Control (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be pretty easy to follow. The driver installation wizard will analyze your PC and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver was not digitally signed.

Driver rating 3.6 stars out of 55992 votes.

2. How to install National Instruments USB-6212 Mass Termination driver using DriverMax

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's take a look!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the National Instruments USB-6212 Mass Termination driver. Click the Update button.
4.  
5. Finished installing the driver!
6.