Realtek TUC-ET2G - two ways of downloading and installing the driver

TUC-ET2G is a Network Adapters device. This Windows driver was developed by Realtek. The hardware id of this driver is USB/VID_20F4&PID_E02B&REV_3004.

1. How to manually install Realtek TUC-ET2G driver

1. Download the driver setup file for Realtek TUC-ET2G driver from the location below. This is the download link for the driver version 10.28.1002.2018 released on 2018-10-02.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

Realtek applied a digital signature to this driver.
File size of the driver: 297961 bytes (290.98 KB)
This driver received an average rating of 5 stars out of 46134 votes.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to install Realtek TUC-ET2G driver using DriverMax

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the Realtek TUC-ET2G driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.