Marvell Synology E10G18-T1 driver download and installation

Synology E10G18-T1 is a Network Adapters hardware device. The developer of this driver was Marvell. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1D6A&DEV_07B1&SUBSYS_10017053&REV_02.

1. Marvell Synology E10G18-T1 - install the driver manually

1. Download the driver setup file for Marvell Synology E10G18-T1 driver from the link below. This is the download link for the driver version 3.1.8.0 dated 2023-04-17.
2.  
3. Run the driver installation file from a Windows account with administrative rights. If your User Access Control (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, it is as simple as that.
8.  

There is no digital signature available for this driver.

This driver was rated with an average of 3.5 stars by 75975 users.

2. How to use DriverMax to install Marvell Synology E10G18-T1 driver

The most important advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's take a look!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the Marvell Synology E10G18-T1 driver. Click the Update button.
4.  
5. Finished installing the driver!
6.