Driver for Marvell Synology E10G18-T1 - downloading and installing it

Synology E10G18-T1 is a Network Adapters hardware device. This Windows driver was developed by Marvell. PCI/VEN_1D6A&DEV_07B1&SUBSYS_10017053&REV_02 is the matching hardware id of this device.

1. Manually install Marvell Synology E10G18-T1 driver

1. You can download from the link below the driver installer file for the Marvell Synology E10G18-T1 driver. The archive contains version 3.1.4.0 dated 2021-08-11 of the driver.
2.  
3. Start the driver installer file from a user account with the highest privileges (rights). If your UAC (User Access Control) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver is digitally signed.
Size of this driver: 152334 bytes (148.76 KB)
Driver rating 4.1 stars out of 22746 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to install Marvell Synology E10G18-T1 driver using DriverMax

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the Marvell Synology E10G18-T1 driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.