Driver for Marvell Synology E10G18-T1 - downloading and installing it

Synology E10G18-T1 is a Network Adapters device. This driver was developed by Marvell. PCI/VEN_1D6A&DEV_07B1&SUBSYS_10017053&REV_02 is the matching hardware id of this device.

1. Marvell Synology E10G18-T1 driver - how to install it manually

1. Download the setup file for Marvell Synology E10G18-T1 driver from the link below. This download link is for the driver version 2.2.3.0 released on 2021-02-12.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is enabled then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Restart your PC and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is digitally signed by Marvell.
The file size of this driver is 132058 bytes (128.96 KB)
Driver rating 4.5 stars out of 76165 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install Marvell Synology E10G18-T1 driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver using DriverMax? Let's take a look!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Marvell Synology E10G18-T1 driver. Click the Update button.
4.  
5. Enjoy using the updated driver! :)
6.