Driver for National Instruments Static Digital Firmware Loader - downloading and installing it

Static Digital Firmware Loader is a DAQ Device device. This driver was developed by National Instruments. In order to make sure you are downloading the exact right driver the hardware id is USB/VID_3923&PID_7320&REV_0100.

1. How to manually install National Instruments Static Digital Firmware Loader driver

1. Download the setup file for National Instruments Static Digital Firmware Loader driver from the link below. This download link is for the driver version 23.3.0.49311 dated 2023-04-01.
2.  
3. Start the driver installation file from a Windows account with the highest privileges (rights). If your User Access Control Service (UAC) is running then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be pretty easy to follow. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Restart your computer and enjoy the new driver, it is as simple as that.
8.  

This driver is not digitally signed.

This driver received an average rating of 3.8 stars out of 20296 votes.

2. The easy way: using DriverMax to install National Instruments Static Digital Firmware Loader driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How can you install a driver using DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you find the National Instruments Static Digital Firmware Loader driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.