Marvell Solo 10G Thunderbolt 3 Edition - two ways of downloading and installing the driver

Solo 10G Thunderbolt 3 Edition is a Network Adapters hardware device. The Windows version of this driver was developed by Marvell. PCI/VEN_1D6A&DEV_87B1&SUBSYS_72E116B8&REV_02 is the matching hardware id of this device.

1. Marvell Solo 10G Thunderbolt 3 Edition - install the driver manually

1. You can download from the link below the driver setup file for the Marvell Solo 10G Thunderbolt 3 Edition driver. The archive contains version 3.0.18.0 dated 2020-11-19 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is running please accept of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver was not digitally signed.

This driver was installed by many users and received an average rating of 3.4 stars out of 31224 votes.

2. Installing the Marvell Solo 10G Thunderbolt 3 Edition driver using DriverMax: the easy way

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How easy can you install a driver using DriverMax? Let's take a look!

1. Start DriverMax and click on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you find the Marvell Solo 10G Thunderbolt 3 Edition driver. Click the Update button.
4.  
5. Finished installing the driver!
6.