Marvell Solo 10G SFP Thunderbolt 3 Edition driver download and installation

Solo 10G SFP Thunderbolt 3 Edition is a Network Adapters hardware device. The developer of this driver was Marvell. The hardware id of this driver is PCI/VEN_1D6A&DEV_80B1&SUBSYS_72E516B8&REV_02.

1. Marvell Solo 10G SFP Thunderbolt 3 Edition driver - how to install it manually

1. Download the driver setup file for Marvell Solo 10G SFP Thunderbolt 3 Edition driver from the location below. This download link is for the driver version 2.2.3.0 dated 2021-02-12.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your UAC (User Access Control) is started then you will have to accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which should be quite easy to follow. The driver setup wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the updated driver, it is as simple as that.
8.  

This driver is digitally signed.
File size of the driver: 132058 bytes (128.96 KB)
This driver received an average rating of 4.3 stars out of 75769 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install Marvell Solo 10G SFP Thunderbolt 3 Edition driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and click on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Marvell Solo 10G SFP Thunderbolt 3 Edition driver. Click on Update.
4.  
5. Finished installing the driver!
6.