Kvaser AB SmartCraft Diagnostic Interface how to download and install the driver

SmartCraft Diagnostic Interface is a CanDevices device. The Windows version of this driver was developed by Kvaser AB. USB/VID_0BFD&PID_0022&REV_0001 is the matching hardware id of this device.

1. Manually install Kvaser AB SmartCraft Diagnostic Interface driver

1. You can download from the link below the driver installer file for the Kvaser AB SmartCraft Diagnostic Interface driver. The archive contains version 8.07.696.0 dated 2014-09-28 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control Service (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your PC and will install the right driver.
6.  
7. When the operation finishes shutdown and restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

There is no digital signature available for this driver.
File size of the driver: 733481 bytes (716.29 KB)
Driver rating 3.1 stars out of 5250 votes.
This driver was released for the following versions of Windows:

• This driver works on Windows 2000 32 bits
• This driver works on Windows Server 2003 32 bits
• This driver works on Windows XP 32 bits
• This driver works on Windows Vista 32 bits
• This driver works on Windows 7 32 bits
• This driver works on Windows 8 32 bits
• This driver works on Windows 8.1 32 bits
• This driver works on Windows 10 32 bits
• This driver works on Windows 11 32 bits

2. How to use DriverMax to install Kvaser AB SmartCraft Diagnostic Interface driver

The most important advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Search the list until you locate the Kvaser AB SmartCraft Diagnostic Interface driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.