CSR SPH10 - two ways of downloading and installing the driver

SPH10 is a USB Universal Serial Bus hardware device. This Windows driver was developed by CSR. The hardware id of this driver is USB/VID_092b&PID_5010.

1. CSR SPH10 - install the driver manually

1. Download the setup file for CSR SPH10 driver from the link below. This download link is for the driver version 2.4.0.0 dated 2011-05-10.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite easy to follow. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.

This driver was installed by many users and received an average rating of 3.8 stars out of 65787 votes.

2. The easy way: using DriverMax to install CSR SPH10 driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Search the list until you locate the CSR SPH10 driver. Click on Update.
4.  
5. Finished installing the driver!
6.