Driver for CSR SH10 - downloading and installing it

SH10 is a USB Universal Serial Bus hardware device. This driver was developed by CSR. The hardware id of this driver is USB/VID_092b&PID_4D25.

1. How to manually install CSR SH10 driver

1. You can download from the link below the driver installer file for the CSR SH10 driver. The archive contains version 2.5.0.1 released on 2013-04-10 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your UAC (User Access Control) is enabled please accept of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. It is as simple as that to install a Windows driver!
8.  

This driver was not digitally signed.

This driver was installed by many users and received an average rating of 3.6 stars out of 12622 votes.

2. How to use DriverMax to install CSR SH10 driver

The advantage of using DriverMax is that it will setup the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
2.  
3. Take a look at the list of detected driver updates. Scroll the list down until you locate the CSR SH10 driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.