Marvell SANLink3 N1 10Gbit Network Adapter - two ways of downloading and installing the driver

SANLink3 N1 10Gbit Network Adapter is a Network Adapters hardware device. The developer of this driver was Marvell. The hardware id of this driver is PCI/VEN_1D6A&DEV_D107&SUBSYS_7202105A&REV_02; this string has to match your hardware.

1. Marvell SANLink3 N1 10Gbit Network Adapter driver - how to install it manually

1. Download the driver setup file for Marvell SANLink3 N1 10Gbit Network Adapter driver from the link below. This download link is for the driver version 3.0.18.0 released on 2020-11-19.
2.  
3. Run the driver installation file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is started then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be quite easy to follow. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
Size of this driver: 567646 bytes (554.34 KB)
This driver was rated with an average of 4.9 stars by 67409 users.
This driver is fully compatible with the following versions of Windows:

• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. Installing the Marvell SANLink3 N1 10Gbit Network Adapter driver using DriverMax: the easy way

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and push on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Search the list until you find the Marvell SANLink3 N1 10Gbit Network Adapter driver. Click on Update.
4.  
5. Enjoy using the updated driver! :)
6.