Marvell SANLink3 N1 10Gbit Network Adapter how to download and install the driver

SANLink3 N1 10Gbit Network Adapter is a Network Adapters hardware device. This Windows driver was developed by Marvell. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1D6A&DEV_87B1&SUBSYS_7202105A&REV_02.

1. Marvell SANLink3 N1 10Gbit Network Adapter driver - how to install it manually

1. You can download from the link below the driver setup file for the Marvell SANLink3 N1 10Gbit Network Adapter driver. The archive contains version 3.1.8.0 dated 2023-04-17 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your UAC (User Access Control) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver setup wizard, which will guide you; it should be pretty easy to follow. The driver setup wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

This driver received an average rating of 3.7 stars out of 74298 votes.

2. How to use DriverMax to install Marvell SANLink3 N1 10Gbit Network Adapter driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How easy can you install a driver using DriverMax? Let's follow a few steps!

1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Search the list until you find the Marvell SANLink3 N1 10Gbit Network Adapter driver. Click on Update.
4.  
5. That's all, the driver is now installed!
6.