Marvell SANLink3 10Gbit SFP Network Adapter driver download and installation

SANLink3 10Gbit SFP Network Adapter is a Network Adapters device. This driver was developed by Marvell. The hardware id of this driver is PCI/VEN_1D6A&DEV_80B1&SUBSYS_7201105A&REV_02.

1. How to manually install Marvell SANLink3 10Gbit SFP Network Adapter driver

1. You can download from the link below the driver installer file for the Marvell SANLink3 10Gbit SFP Network Adapter driver. The archive contains version 3.1.8.0 dated 2023-04-17 of the driver.
2.  
3. Start the driver installer file from a user account with administrative rights. If your User Access Control (UAC) is started please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which will guide you; it should be quite easy to follow. The driver installation wizard will scan your computer and will install the right driver.
6.  
7. When the operation finishes restart your PC in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is not digitally signed.

Driver rating 3.3 stars out of 74346 votes.

2. Using DriverMax to install Marvell SANLink3 10Gbit SFP Network Adapter driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How easy can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your computer.
2.  
3. Take a look at the list of available driver updates. Scroll the list down until you locate the Marvell SANLink3 10Gbit SFP Network Adapter driver. Click the Update button.
4.  
5. Finished installing the driver!
6.