ad-block

Advertising seems to be blocked by your browser.

The ads help us provide this software and web site to you for free.

Please support our project by allowing our site to show ads.



Download and install Marvell SANLink3 10Gbit SFP Network Adapter driver


SANLink3 10Gbit SFP Network Adapter is a Network Adapters hardware device. This driver was developed by Marvell. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1D6A&DEV_80B1&SUBSYS_7201105A&REV_02.

1. Marvell SANLink3 10Gbit SFP Network Adapter driver - how to install it manually


  1. Download the driver setup file for Marvell SANLink3 10Gbit SFP Network Adapter driver from the link below. This download link is for the driver version 3.0.19.0 released on 2021-01-22.
  2.  
  3. Run the driver installation file from a Windows account with the highest privileges (rights). If your UAC (User Access Control) is running then you will have to accept of the driver and run the setup with administrative rights.
  4.  
  5. Go through the driver setup wizard, which should be quite straightforward. The driver setup wizard will analyze your PC for compatible devices and will install the driver.
  6.  
  7. Shutdown and restart your computer and enjoy the fresh driver, as you can see it was quite smple.
  8.  
This driver is digitally signed by the manufacturer.
File size of the driver: 568707 bytes (555.38 KB)
Driver rating 4.9 stars out of 31215 votes.
This driver is fully compatible with the following versions of Windows:

  • This driver works on Windows 8.1 64 bits
  • This driver works on Windows 10 64 bits
  • This driver works on Windows 11 64 bits



2. Using DriverMax to install Marvell SANLink3 10Gbit SFP Network Adapter driver


The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date, not just this one. How can you install a driver using DriverMax? Let's see!

  1. Start DriverMax and push on the yellow button named ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to scan and analyze each driver on your PC.
  2.  
  3. Take a look at the list of detected driver updates. Scroll the list down until you find the Marvell SANLink3 10Gbit SFP Network Adapter driver. Click on Update.
  4.  
  5. Finished installing the driver!
  6.  

Drivers