QLogic QLogic Fibre Channel Adapter - two ways of downloading and installing the driver

QLogic Fibre Channel Adapter is a SCSI Adapter hardware device. This driver was developed by QLogic. PCI/VEN_1077&DEV_2432&SUBSYS_01541077&REV_02 is the matching hardware id of this device.

1. How to manually install QLogic QLogic Fibre Channel Adapter driver

1. You can download from the link below the driver setup file for the QLogic QLogic Fibre Channel Adapter driver. The archive contains version 9.1.9.27 dated 2011-06-09 of the driver.
2.  
3. Run the driver installer file from a user account with the highest privileges (rights). If your User Access Control Service (UAC) is enabled please confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Follow the driver setup wizard, which will guide you; it should be quite easy to follow. The driver setup wizard will analyze your computer and will install the right driver.
6.  
7. When the operation finishes restart your computer in order to use the updated driver. As you can see it was quite smple to install a Windows driver!
8.  

This driver is digitally signed by the manufacturer.
Size of this driver: 1011462 bytes (987.76 KB)
Driver rating 5 stars out of 50759 votes.
This driver is compatible with the following versions of Windows:

• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. How to use DriverMax to install QLogic QLogic Fibre Channel Adapter driver

The advantage of using DriverMax is that it will setup the driver for you in the easiest possible way and it will keep each driver up to date, not just this one. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the QLogic QLogic Fibre Channel Adapter driver. Click the Update button.
4.  
5. That's it, you installed your first driver!
6.