QLogic QLogic Fibre Channel Adapter - two ways of downloading and installing the driver

QLogic Fibre Channel Adapter is a SCSI Adapter hardware device. This Windows driver was developed by QLogic. In order to make sure you are downloading the exact right driver the hardware id is PCI/VEN_1077&DEV_2432&SUBSYS_01381077&REV_02.

1. QLogic QLogic Fibre Channel Adapter - install the driver manually

1. Download the setup file for QLogic QLogic Fibre Channel Adapter driver from the location below. This download link is for the driver version 9.1.9.27 dated 2011-06-09.
2.  
3. Start the driver setup file from a Windows account with the highest privileges (rights). If your User Access Control (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty easy to follow. The driver installation wizard will scan your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your computer and enjoy the new driver, as you can see it was quite smple.
8.  

This driver is digitally signed.
File size of the driver: 1011462 bytes (987.76 KB)
Driver rating 5 stars out of 25462 votes.
This driver will work for the following versions of Windows:

• This driver works on Windows Vista 64 bits
• This driver works on Windows 7 64 bits
• This driver works on Windows 8 64 bits
• This driver works on Windows 8.1 64 bits
• This driver works on Windows 10 64 bits
• This driver works on Windows 11 64 bits

2. The easy way: using DriverMax to install QLogic QLogic Fibre Channel Adapter driver

The most important advantage of using DriverMax is that it will install the driver for you in the easiest possible way and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Start DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your PC.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you find the QLogic QLogic Fibre Channel Adapter driver. Click the Update button.
4.  
5. That's all, the driver is now installed!
6.