National Instruments PCI-GPIB how to download and install the driver

PCI-GPIB is a GPIB device. The developer of this driver was National Instruments. The hardware id of this driver is PCI/VEN_1093&DEV_C811&SUBSYS_00000000&REV_01.

1. How to manually install National Instruments PCI-GPIB driver

1. Download the driver setup file for National Instruments PCI-GPIB driver from the link below. This download link is for the driver version 3.0.0.49152 dated 2011-10-13.
2.  
3. Start the driver installation file from a Windows account with administrative rights. If your User Access Control Service (UAC) is enabled then you will have to confirm the installation of the driver and run the setup with administrative rights.
4.  
5. Go through the driver installation wizard, which should be pretty straightforward. The driver installation wizard will analyze your PC for compatible devices and will install the driver.
6.  
7. Shutdown and restart your PC and enjoy the fresh driver, as you can see it was quite smple.
8.  

This driver is not digitally signed.

This driver was rated with an average of 3.8 stars by 20399 users.

2. Using DriverMax to install National Instruments PCI-GPIB driver

The advantage of using DriverMax is that it will install the driver for you in just a few seconds and it will keep each driver up to date. How can you install a driver with DriverMax? Let's follow a few steps!

1. Open DriverMax and press on the yellow button that says ~SCAN FOR DRIVER UPDATES NOW~. Wait for DriverMax to analyze each driver on your computer.
2.  
3. Take a look at the list of driver updates. Scroll the list down until you locate the National Instruments PCI-GPIB driver. Click on Update.
4.  
5. That's it, you installed your first driver!
6.